Looking at section H of the 2007 Rule book... was it reverted back to the 2005 standards?
Announcement
Collapse
No announcement yet.
2007 Dyno Plot requirements...
Collapse
X
-
Re: 2007 Dyno Plot requirements...
If you check out the Dyno Plot form (available on the web site) I think you will see that the expectations are almost identical to 2006. The only change is that the pulls must be done in the gear closest to 1:1 unless another gear gives a higher result, in which case that gear must be used.James Mewett
CCC Lurker
-
set tire pressures to winning!
Comment
Comment